Sunday, April 18, 2010

Hinge replaced, frame mods completed

This afternoon I resumed work on the frame rods I started on previously.  

The only thing I was missing was some shorter screws and a some washers to make up for any shortfalls in my cutting.

It turns out user one washer on each side worked fine.  

It turns out that one hole is bit off from centerline so it looks a bit awry....but will work fine.

Finally, after letting the Goop adhesive dry overnight, I was able to see how the JAG hinge is working out.  As you can see in the photo below, these work great!

I began work on mounting a servo for the new door hinge and charging panel.  Next time I will show you how those are working out.