Working on the Center Vent internals

Tonight I started on the vent internals again. A few days ago, Tom Doucet mailed a replacement pack of internal pieces!

I looked over the pieces and did some careful filing where required.

Once I had a good test fit, I hot glued the pieces into place. One of the internals is vastly easier to work with if you hot glue it to the table!


Once the hot glue had set and I was comfortable with the alignment, I got the JB Kwik ready to go.

If there is anything that smells worse than JB Kwik, I have yet to experience it.

As best I could with a popsickle stick, I dabbed the JB on the pieces.

Once this stuff dries, I'll pry off the Hot Glue and move on!